Prexiso T.O.2 Manuel De L'utilisateur page 34

Adjustment
5. If the laser point remains at the center of the cross mark, no adjustment is
required; otherwise adjust as follows.
1. Remove the protective cover of the
laser plummet and adjust the adjust-
ment screws of the laser plummet,
using the hexagonal wrench, so that
the laser point moves the half of the
offset a towards the cross mark.
2. Repeat the steps 2. to 5. in "Inspec-
tion" and step 1. in "Adjustment" until
the laser point superposition.
a
T.O.2 | 32