Motor Installation - Jilong CHEYENNE V Série Manuel D'instructions

INSTALLATION
Structure of the safety valve
A. Valve cap
B. Inflating mouth
C. Deflation button
D. Protective sheath
D
After the inflation adapter is assembled completely, you can inflate the boat by
number sequence. Do not over inflate. After inflating, screw the Valve Cap A in
clockwise direction by hand. Caution: Do not over inflate or use high-pressure
pump.
Fill each chamber until it is stiff. Measure the printed ruler to 10cm with the
equipped hard ruler to check the main chamber for proper inflation.
0.15bar(2.18PSI) for chamber 1,2,3
0.10bar(1.45PSI) for chamber 4
Deflating
Remove the valve cap A, push down the deflation button C and turn the valve
clockwise direction by 90° until its is locked, release the valve and the air will flow
out. If you want to stop the deflation, push down the deflation button C and turn
it in counter-clockwise direction by 90°. The deflation will stop when the valve is
released.
Place the inflated Cushion Seat upper the boat bottom, close the locking clasps
and fasten the buckle and adjust the belt to a suitable length for comfort.
8
A
C B
www.jilong.com CBV-13-GB
INSTALLATION
Oars Assembly:
Take a coupler and unscrew a few turns each of the two screw collars. Insert an
oar blade into one end a handle into the other. Tighten up both screw collars.
Repeat above steps to assemble the other oar.
Installing oars to row the boat:
Insert the assembled oar into the oar lock by sliding the handle from outside the
boat through the oar lock. Slide the oar retaining ring onto the handle and down
the handle shaft to the oar lock. This will prevent the oar from sliding out into the
water. Please see below illustration.

Motor Installation:

To fit a motor onto the motor board please follow the instructions of your Motor
Installation Manual.
9 www.jilong.com CBV-13-GB