Led Light; Angle Attachment; Service And Maintenance; Storage - Mafell A10 M Traduction De La Notice D'emploi Originale

One screwdriver bit can be accommodated in the bit
adapter (11).

5.10 LED light

(Fig. 1)
The LED light (2) is switched on and off via the main
switch.

5.11 Angle attachment

With the angle attachment (Fig. 7) you can carry out
screwing and drilling tasks at right angles to the
screwdriver axis. It is possible to set angles at 30°
increments to the screwdriver axis.
Detaching: Pull the locking ring forward and pull off
the angle attachment to the front.
Attaching: Pull the locking ring forward and push the
angle attachment up to the limit stop onto the drilling
spindle (if necessary, turn the angle attachment lightly
to and fro).
6

Service and maintenance

Danger
Unplug the rechargeable battery for
all service work.
MAFELL machines are designed to be low in
maintenance.
Always keep the appliance clean.
Should the appliance
manufacturing and testing procedures, the repair
must be carried out by an authorised customer
service station for MAFELL electrical tools.
Store the appliance in a dry and frost-proof place.
Only use MAFELL accessories and spare parts. Have
components, the replacement of which has not been
described, replaced at a MAFELL customer service
station.

6.1 Storage

If the machine is not used for a longer period of time,
it has to be carefully cleaned. Spray bright metal parts
with a rust inhibitor.
fail despite thorough
-18-

6.2 Transport

The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. The user
can transport the batteries by road without further
requirements.
When being transported by third parties (e.g.: air
transport or forwarding agency), special requirements
on packaging and labelling must be observed. For
preparation of the item being shipped, consulting an
expert for hazardous material is required.
Dispatch batteries only when the housing is
undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot
move around in the packaging.
Please also observe possibly more detailed national
regulations.

6.3 Disposal of rechargeable batteries/batteries

The machine, rechargeable
batteries, accessories and
packaging should be sorted for
environmental-friendly recycling.
Do not dispose
batteries/rechargeable
waste!
Only for EC countries:
According to the European
Guideline 2002/96/EC, power tools
that are no longer usable, and
according to the European
Guideline 2006/66/EC, defective or
used battery packs/batteries, must
be collected separately and
disposed of in an environmentally
correct manner.
Battery packs/batteries:
Li-Ion:
Please observe the instructionsin
section "Transport",page 18.
Subject to change without notice.
of power tools
batteries into household
and