Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Power on / off
Power on
•
Open the charging box lid and take out the earphones. The
earphones should activate automatically.
•
If the earphones were outside of the case for a longer time,
or have been deactivated by other means, push the MFB for
1 second to start them up.
When activating, the blue Indicator LED will light up for 1 second and
you will hear „power on".
Power off
•
Put the earphones back into the charging case and close the
cover. The earphones will deactivate automatically.
•
If the charging box is not available, or out of power, you can
also press the MFB for 10 seconds until the red indicator LED
lights up for 1 second and you hear „power off".
Factory Reset
1.
Switch off both earphones.
2.
Then press the multifunction button on both earphones for
10 seconds to reset the system.
20
Pairing
Stereo mode
1.
Open the charging case and take out the Earphones to power
them on (alternatively refer to step 2 under „power on")
2.
The earphones automatically enter pairing search mode.
3.
Activate Bluetooth® on your device (e.g. smartphone) and
choose „CHRONOS AIR PRO" from the connection list.
Mono Mode
1.
Open the charging case and take out only one (left or right)
earphone.
2.
The single earphone automatically enters pairing search
mode.
3.
Activate Bluetooth® on your device (e.g. smartphone) and
choose „CHRONOS AIR PRO" from the connection list.
Relink headphones
The left and right Earphone are linked togehter factorywise.
If under any circumstances, the two Earphones loose connection,
please try the folowing steps, to relink them:
1.
Put both Earphones into the charging case and take them
out again.
2.
If step 1 is not successful, press the multifunction button on
both earphones for 10 seconds to reset the system. Proceed
with step one.
EN
21
Publicité
Table des Matières
