Tool Maintenance; Spare Parts - Scell-it E-412NA Premium Série Guide Rapide

TOOL MAINTENANCE

During maintenance the tool must be disconnected from the source of compressed air !!!
1. DAILY MAINTENANCE
Daily, before starting work, apply several drops of lubricating oil (we recommend hydraulic
oil grade HLP ISO VG 32) into the air inlet of the tool, on condition there is no lubricating
device connected in the air distribution. If the tool is in continuous operation, it is necessary to
disconnect the air hose from the main air supply and lubricate the tool every 2 or 3 hours.
Check the tool for air leakage, if necessary replace damaged hoses and clasps.
If the pressure regulator is not equipped with a filter, blow through the air hose before its
connection to the tool in order to get rid of impurities and water. If the pressure regulator has a
filter, dry it out.
Check whether the fixed nose-piece corresponds to the BR diameter and that all screw threads
and joints are tightened properly.
Check whether the air outlets are really empty.
2. WEEKLY MAINTENANCE
Cleaning of the tool and replacement of worn or non-functional parts.
Unscrew the anvil and mandrel according to the chapter «2. TOOL OPERATION» p.3 from 1 to
3 and clean them thoroughly.
Visually check - especially the mandrel, anvil and front nozzle - if worn or damaged, replace them.
Dismounted parts should be reinstalled according to the chapter «2. TOOL OPERATION» p.4
from 5 to 7 including setting up according to the point 8.
3. GENERAL MAINTENANCE
General maintenance should be performed after about 500 000 strokes or once every three years.
The tool must be completelly disassembled and all seals and worn parts must be replaced. This
repair may be carried out by an authorized technician only or a person trained by the manufacturer
or supplier.

SPARE PARTS

1. ORDERING
Order the spare parts exlusively from the manufacturer or from your sales agents.
The order must contain:
a) tool serial number
b) number of ordered part
c) number of pieces
d) name of your company and precise address
e) your tax identification number and identification number
2. LIST OF QUICKLY EXPENDABLE PARTS
- All types and dimensions of mandrels and anvils «2. TOOL OPERATION» p.3
- Front nozzle complete S-1400600
• 5
E-412NA - User Manual
EN
FR
IT