WAGNER FURNO 550 Guide D'utilisation page 9

Cool down Mode (Fig. 6)
While the heat gun is
operating, press the power
button once to enter cool
down mode. When cool down
mode is entered, the gun
will run for 3 minutes with
maximum air flow. During this
period, the blue cool down
light will illuminate to indicate
cooling. To override cool down
mode, press and hold the
power button for 2-3s.
8
EN
6
Startup
1. Plug the unit into a standard wall outlet.
2. Turn on the heat gun by pressing the power button on the Control
Panel (Fig. 4, 1). When the gun is turned on, it is automatically set
in the low temperature range (Fig. 5, a) at 150ºF and a low air flow
setting.
3. If you wish to continue working within the low temperature range,
simply press the plus or minus button on the touch pad until your
desired temperature setting is selected, this will be indicated by
the temperature bar being lit.
4. If you wish to operate within the high temperature range and high
air flow setting, press the Mode Selector button (Fig. 4, 2) once. The
high temperature range indicator light will turn on. You can now
simply press the plus or minus button on the touch pad until you
reach your desired temperature setting, this will be indicated by
the temperature bar being lit.
IMPOrTaNT: If the blower motor in the heat gun does not turn
on when the POWer button is activated, turn the switch OFF
immediately. The heating element will burn out if it is not cooled by
the blower.
5. During rest periods or when you are finished with your project,
press the power button to enter cool down mode.
6. Set the gun down in an upright position. The heat gun will shut
itself off after 30 seconds.
Following cool down mode the barrel of the heat gun
may still be hot.
Note: Smoke may appear during the initial start up due to
the burning of manufacturing oils. The smoke should
disappear in less than a minute.