WAGNER FURNO 550 Guide D'utilisation page 10

Carry Case (optional) (Fig. 7)
The heat gun case has been
specifically designed to
secure the heat gun in the
upright position for work
on uneven surfaces (see
AngleLoc, below).
angleLoc™ (Fig. 8)
a: Insert the back of the heat gun so that the rear stabilizing fins
locate themselves below the ridges on the side wall of the cavity in
the top of the carry case.
B: Then slide the heat gun forward so that it naturally locks into place
at a 135 degree angle. The heat gun should now be secure for
upright use.
8a
7
8b
Note: always set the heat gun upright after it is turned off, either
for a short break or for storage. avoid laying the unit on
the side after shutdown. The heat will remain in the unit
and cooling will take longer. Store the unit only after the
nozzle is cool. Unplug the unit before storing to prevent
accidental startup.
Many variables affect heating applications, such as the material being
heated, ambient temperature, the distance from the gun to the substrate
and the heating technique. For this reason, Wagner has provided
temperature guidelines for certain applications. Always start the heat
gun at the lowest temperature in the range then raise the temperature
until the optimum temperature is achieved. Always keep the heat gun in
motion and at least 2" from the substrate when applying heat.
For more details on multiple projects and 'how to' videos please visit our
website - www.wagnerspraytech.com.
IMPOrTaNT: always protect glass when working near windows.
do not touch nozzle or the scraper blade when working.
These become extremely hot and will cause severe burns.
Wear gloves to protect hands from hot scrapings.
9
EN