Run The Schedule; Run Schedule From Slideshow; Run Schedule From Calendar/Clock Screen; Set The Date And Time - HP df730v1 Manuel De L'utilisateur

Run the Schedule

After the schedule times have been set (per above instructions), you will use the Run Schedule function
whenever you want the schedule to take effect.
There are two methods for running the schedule, either from a slideshow or from the
CALENDAR/CLOCK screen.
! CAUTION: After you select the Run Schedule function, any user intervention will cancel the activation

Run Schedule from Slideshow

1. Start a slideshow, and then press
A small timer clock will appear indicating the schedule is active. To run the schedule when the Run
Schedule button is no longer displayed, restart your slideshow and then press
Schedule button appears again.
2. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
slideshow will again begin to play.

Run Schedule from CALENDAR/CLOCK Screen

1. On the CALENDAR/CLOCK screen, press
2. Select Run Schedule. A small timer clock will appear indicating the schedule is active, and then the DPF
will operate according to the set schedule.
3. The DPF will go into stand-by mode according to the schedule, and when it resumes operation, the
Calendar/Clock screen will again be displayed.

Set the Date and Time

1. On the CALENDAR/CLOCK screen, press
2. Select Set Date/Time, and then select the options and use
3. Select Done.
DPF to PC – USB Connection
You can connect the DPF to a Windows PC or Macintosh computer via a USB cable to copy files between the
computer and the DPF's internal memory.
If you have memory cards inserted in the DPF, you can also copy between the PC, internal memory, and
memory cards.
Connect DPF to Windows PC
1. Connect the small end of the USB cable to DPF's Mini USB port, and the larger end to an available USB
port on your computer.
2. A window opens listing all drives connected to your computer.
3. The internal memory (titled HP_DPF) and each memory card present in the DPF will be associated with one
disk drive on your PC.

IMPORTANT: If your PC is connected to Local Area Network drives, or if you have multiple drive letters
(i.e., pressing remote or control button, powering off) and the schedule will not take effect
until you select this function again to re-activate.
already assigned to peripheral devices, you will need to manage your drive settings in
Windows to free up the four drive letters immediately following your CD-ROM drive so the
DPF can assign them to memory card slots properly.
when the Run Schedule button appears (approx 10 seconds).
ENTER
.
.
14
when the Run
ENTER
to change the field values.