Electrical Connection - Fulgor Milano FQMO 4505 MT X Mode D'emploi Pour L'utilisation Et L'entretien

16 - Electrical connection

EN
Before making the electrical connection, make sure that:
• the characteristics of the electricity supply fulfil the
requirements indicated on the serial number plate fixed
on the front of the oven;
• the electricity supply is earthed in accordance with current
laws and regulations. Earthing is required by law. The
cable should not, at any point, exceed 50°C above room
temperature.
This oven must be connected to the power supply with
the power cable and a suitable plug which is compatible
with the socket installed on the electricity supply which is
powering this oven.
If a fixed appliance does not have a power cord and plug,
or another device that ensures disconnection from the
mains, with an opening distance of the contacts that allows
complete disconnection under the conditions of excessive
voltage category III, such disconnection devices must be
provided in the power supply mains conforming to the
installation rules.
The omnipolar socket or switch must be easy to reach when
the appliance is installed.
N.B. The manufacturer declines all responsibility if all of the
above and the usual accident prevention regulations
are not observed.
18
TYPE AND MINIMUM DIAMETER OF THE CABLES
H05RR-F 3x1.5 mm²
H05VV-F 3x1.5 mm²
H05RN-F 3x1.5 mm²
H05V2V2-F 3x1.5 mm²
SASO
H05RR-F 3x2.5 mm²
H05VV-F 3x2.5 mm²
H05RN-F 3x2.5 mm²
H05V2V2-F 3x2.5 mm²