ECG BTS Elysium M1 Mode D'emploi page 36

6. Playing music from micro SD card
After inserting your Micro SD card into the speaker, short press 1 to switch the speaker into memory card
playback mode and play music directly from the Micro SD card. The speaker will indicate "Memory card mode"
before playing.
Note: You can select the next folder in the playback from memory card by long pressing the button 7.
7. AUX IN mode
Connect the speaker to an audio source (PC, MP3MP4, mobile phone) via 3.5mm audio cable. Short press 1 to
enter "AUX IN" mode (speaker indicates "AUX IN"). Music begins to play from the audio source.
Notes:
• If you are connecting the speaker to a computer with a 3.5 mm audio cable, we recommend using
a genuine adapter (5 V / 1 A) to charge the speaker instead of the computer USB port. Powering the device
from the computer may be insufficient.
• Short press 7 to lower the music volume. The source of music continues to play the music at a lower
volume.
GB
8. FM tuner
Short press 1 to initiate FM mode (the speaker indicates "Mode FM"). While in FM mode, long press 7 to
initiate the auto-tuning of FM stations. Short press 5 / 6 to tune to previous/next station.
9. Card reader
Insert your Micro SD card into the speaker and switch OFF. Connect the speaker to the computer via USB cable.
After the speaker switches to memory card mode, files can be read and written to the computer from the Micro
SD card.
Note: The necessary computer driver is installed when using this feature for the first time.
10. Intelligent energy-saving feature
The speaker automatically switches OFF in the following cases:
• The speaker in Bluetooth mode waits longer than 10 minutes to pair.
• Press 7 while in Memory card mode / FM mode / AUX IN mode to stop playback after a period exceeding
10 minutes.
Note: Long press 7 again to switch the speaker ON again.
11. Charging
If the speaker battery is almost empty, the speaker will indicate "battery low". Immediately charge the battery
using the USB adapter. When fully charged, all 4 battery charge indicators light up.
Notes:
• Only use a quality adapter to charge the speaker.
• We recommend using an adapter with the following parameters: 5 V / 1 A, full charge takes about 4 hours.
• Always charge the speaker immediately after the speaker indicates the battery is empty.
• The speaker can also be charged with a lower charging current. The charging cycle can take a very long
time when the battery is charged via standard USB port with a current of 500 mA.
36