Setting - Camera; Extras - REV Ritter JY-229TB Instructions De Montage Et D'utilisation

1.Remove the installation ring from the bottom of the camera
(Fig. 1).
2.Fix the installation ring by means of the accompanying
screws on the desired position (Fig. 2).
3.Select one of the four channels (15) at the bottom of the
camera (see the item "channel selection on the camera").
4.Connect the mains power unit with the camera (16) (Fig 3-5).
5.Put the camera on the installation ring. To engage the
camera with the installation ring, you must rotate the camera
in the clockwise direction (Fig. 6).

Setting - camera

Channel selection on the camera (15):
The audio/video monitoring system has four different channels.
With these, 4 cameras can be displayed on one monitor. The
desired channel for this camera is selected with the help of the
channel selection switch on the bottom side of the camera
(see sketch).
A B C D
Each channel may only be assigned to one camera.

Extras

Infrared
The infrared mode will be switched on automatically during
darkness. The infrared mode allows you to operate the camera
even during darkness. Integrated IR LED lightens the
surrounding in the invisible infrared range. In darkness, the
maximum covered range is approx. 2m. In daylight the infrared
mode is switched off automatically.
15
Four channels can be selected
e.g. Channel B is set.