Meaning Of The Leds - Bonnet Neve MULTIFRESH PLUS EFFICIA Instructions Pour L'utilisateur

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

20. MEANING OF THE LEDS

LED MODE
ON
Flashing
ON
Flashing
ON
Flashing
ON
ON
21. MALFUNCTION AND REMEDIES
Most of the functioning inconveniences are generally due to defective electrical connections.
These problems can usually be solved on the place.
POSSIBLE CAUSE
Check that there is voltage at the wall socket
Check that the unit is properly plugged
Check that the plug cord is broken
If power failure is not due to any of the above causes, call the nearest after-sales service immediately, empty the cabinet and store the foods in
coldrooms or refrigerators that may ensure their preservation temperature.
POSSIBLE CAUSE
Check door is perfectly closed
Make sure that the cabinet has been filled correctly
Check that the unit is not adjacent to sources of heat
Check the temperature setting
Check that behind the cabinet air can properly circulate
If failure to cool should is not due to any of the above reasons it it persists on even after the above checks, resort to the nearest after-sales
service.
POSSIBLE CAUSE
Check that all the bolts and nuts are properly fastened
Check that the unit is placed on an even surface
Check if any pipe or fan is in contact with any other part of the body
Should the inconvenience persist, contact the nearest after-sales service.
MULTIFRESH PLUS EFFICIA
MULTIFRESH BIO
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
MEANING
Active compressor
Delay against close starts
Defrosting in progress
Dripping in progress
Fans on
Fans start delay in progress
A temperature alarm activated
Continuous cycle in progress
THE UNIT DOES NOT START
THE INTERNAL TEMPERATURE IS NOT COLD ENOUGH
THE UNIT IS NOISY
LED MODE
ON
ON
ON
°C
Flashing
ECO
ON
SOLUTION
Insert the plug
Insert the plug correctly
Replace the plug cable
SOLUTION
Close correctly
Load the product correctly
Position the equipment correctly
Set the correct temperature
Position the equipment correctly
SOLUTION
Screw in the screws
Position the equipment correctly
Switch off the counter and distance
the parts in contact in the event the
problem persists, contact the support
service.
2 2 / 6 0
PAGE
UM000470
N° DOC
MEANING
Light on
Auxiliary active
Unit of measurement
Programming
Energy saving in corso
AUTHORISED STAFF
User
User
Technical support
AUTHORISED STAFF
User
User
User
Technical support
User
AUTHORISED STAFF
User
User
Technical support