Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
17. TANK CLEANING
WARNING! TURN OFF POWER SUPPLY TO THE CABINET BY DISCONNECTING THE POWER
PLUG BEFORE CLEANING.
By tank cleaning, proceed as follows:
1.
Place the goods in special refrigerated containers, kept at the same temperature and remove the shelves.
2.
Before cleaning the tank the inside temperature must be equal to the ambient temperatur.
3.
Leave the doors open and begin the operation of tank washing when the tank temperature is the same as the ambient temperature.
4.
Proceed with washing and drying the internal chamber with a cloth using neutral PH detergent and fresh water.
5.
Clean the surfaces with a cloth, using neutral PH detergent, rinse and dry.
6.
Clean the height adjusters supporting the levels with a jet of air.
7.
Avoid water entering into the appliance lighting units.
8.
Then plug the unit and wait till the appliance reaches the right temperature before filling it again.
Do not use any aggressive or abrasive cleaning agents.
Never use a water hose or a high-pressure jet to clean the cabinet.
WARNING! Do not use jet of water to clean the cabinet: electrical wiring could be damaged.
WARNING! Never use mechanical devices or any other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
18. WATER COLLECTION TANK CLEANING
Attention!
Clean based on use and need and in particular environmental conditions (e.g.
high humidity, low room temperature, presence of dust, etc.) to avoid incorrect
and incomplete evaporation of water and/or presence of unpleasant odours.
19. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-established
temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
•
Press the (Set) (2 sec.) key in order to see on display the temperature set point.
•
Press the () key or the () key in order to increment or decrement the temperature set point.
•
Press the (Set ) key in order to store the new temperature set point.
1
2
3
1. Light switch
2. Automatic defrosting button
3. Button to show set temperature
4. Button to decrease temperature
5. Button to increase temperature
MULTIFRESH PLUS EFFICIA
MULTIFRESH BIO
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
4
1
2
5
3
2 1 / 6 0
PAGE
UM000470
N° DOC
4
5
Publicité
Table des Matières
