Tips For Use - Princess 1950 Mode D'emploi

TIPS FOR USE

Plug the Princess Juicer into the socket and turn it on with the switch at the back.
Type 1950
The motor will be activated but the juicing cone will remain still because of the automatic clutch. The
juicing cone will only rotate when pressure is applied.
Type 1951
The juicing cone will only turn once the lid is closed or when the lid of the juicer is removed.
Fig. 2 Drip control mechanism open
Pressing, Type 1950 and 1951:
Cut the citrus fruit into two equal halves. Place one half onto the middle of the juicing cone and press
lightly. Put a glass under the spout (first open the drip stop for type 1951). Now close the lid. The juicing
cone will rotate. Exert even pressure until juice stops coming out of the fruit.
Tip: Juicing is easier when the fruit is placed on the press point of the lid. Make sure that the fruit is tilted
slightly forward (see fig 3).
Fig. 3
Do not press too hard. If you hear the motor rotating more slowly or if it stops, you are pressing too hard.
The motor will not become damaged because the thermal protective device turns the motor off if it is
overstrained. If this occurs, we advise you to turn the juicer off with the on/off switch. After a few
minutes, the motor will cool down and the Princess Juicer can be used again. Always switch the juicer off
after use.
In some cases, it is easier to press half on the juicing cone with your hand instead of the lid. This method
is recommended when the fruit, such as small oranges, lemons and large grapefruits, do not fit onto the
juicing cone. This method is also recommended for hard (refrigerated) fruit.
For type 1950, it is easy to press the fruit half onto the cone with your hand. For the type 1951, the lid
must first be removed. To remove the lid, press the lid release (see fig. 4) on the back of the closed lid
and then pull the lid up. The motor will now turn continuously.
Fig. 4 To replace the lid, follow
the above steps in reverse
order.
CLEANING
FIRST UNPLUG THE CORD FROM THE SOCKET
Clean the juicer after each use to prevent leftover food from sticking. The pressure cone,
the reservoir and the drip tray can be easily removed by pulling them up. Do not wash
these in the dishwasher. Each component can be washed in hot soapy water, with the
exception of the motor base. Do not use abrasive or strong detergents. Wipe the motor base
with a damp cloth.
6