Ebode PMML Guide Utilisateur page 9

Transmitter & Receiver - Remote Controlled Appliance Kit Ref : PMML
C. Set the UNIT CODE.
- Repeat step A only.
- Press the (0) button as many times as needed to get to the desired UNIT
CODE and then release it.
Example: 1 = press once, 2 = press twice, 3 = press 3 times... 16 = press 16
times.
After having set the UNIT code, the LED will flash YELLOW 3 times.
3.2 HOW TO PROGRAM THE MICRO RECEIVER
The Micro Transmitter commands must be recognized in order to add the Micro
Receiver to a different installation from the original or to one with interference
from a nearby system.
1. Install the Micro Receiver (Paragraph 3)
2. Proceed to make a "Reset". Press down and hold the button in the (PROG)
opening with a paper clip until the LED lights up GREEN, then release it.: the
LED should flash YELLOW: the Micro Receiver now has no code.
3. With the paper clip, press down briefly in the (PROG) opening. The LED
will flash GREEN and wait for a command from a Micro Transmitter or remote
control switch.
4. Press one of the buttons on the Micro Transmitter or the remote control
switch: the Micro Receiver LED will stop blinking, confirming it has received the
command. The programming is done!
REMARKS
The RMML Micro Receiver will remember as many Micro-Transmitters and re-
mote control switches as necessary.
VERIFICATION
VerifyOn/Off switch operation.
You must wait about a second between each On / Off command.
When changing the battery, the registered code will be retained by the Micro
Transmitter.
Troubleshooting -
please check FAQ and technical support on
www.ebodeelectronics.eu
July 2009 page 9 PMML