Table des Matières
Publicité
System
B = Body
C = Chassis
P = Propulsion system
U = Network
Code type
0 = General
1 = Manufacturer-
specific
Check whether the vehicle has a 16-pole
OBD II socket. Check the vehicle emission
control label (VECI Label) to see if your
vehicle can be diagnosed.
The OBD II socket is located in the area of
the fuse box below the dashboard in most
vehicles. Should you not find the OBD II–
socket, please see the vehicle manual or ask
your vehicle manufacturer.
The AEG OBD II diagnostic device OL 8000
works with all vehicles and small vans built
as from 2000 with petrol engines and 2003
with diesel engines, which are equipped with
OBD II-socket and contain the following
diagnostic protocols: VPW, CAN, PWM,
KWP2000, ISO 9141 and EKWP2000.
The AEG OBD II diagnostic device OL 8000
reads and deletes general and manufacturer
specific diagnosed error codes (DTC's) out of
the engine control device
Vehicles built as from 2002 which are support-
ed with the mode 9, the VIN (Vehicle Identi-
fication Number) of the vehicle is read out.
With this device, the status of the malfunc-
tion warning light (MIL) can be deleted. In
addition the emission-display status can be
monitored.
DTC Example
P 0 2 0 2
Sub-System
1 = Fuel / Air /
lambda sensor
2 = Air inlet- and
pressure system
3 = Ignition, misfire
control
4 = Emissions- and
exhaust control
5 = Speed – and bra-
ke control system
6 = Engine manage-
ment / Board
computer
7 = Gear box / Hyd-
raulic sensors
8 = Gear box /
Hydraulic pressu-
re
9 = Automatic gear
For this device a separate power supply is
not required. The power supply and data
transfer follows via the connection cable in
combination with the on-board computer of
the vehicle.
Read out error codes
IMPORTANT NOTE! Switch of the vehicle be-
fore error diagnosis. The OBD II device must not
be connected while the engine is still running or
the ignition is still switched on.
Start error diagnosis
1. Switch off the ignition of the vehicle
2. Connect the OBD II connection plug
the OBD II connection socket of the vehicle.
3. Wait a short moment until the device is
ready for operation and »AUTOSCAN
8400« is displayed in the LC-Display
4. Now switch on the ignition but do not start
the engine! If the LC-display
»ERROR« message, switch of the ignition of
the vehicle and wait for approx. 20 seconds
Start-up / Operation
The error code shows
which component is
damaged.
with
4
.
1
shows an
1
GB
37
Publicité
Chapitres
Table des Matières
