Before Starting The Equipment - Pattfield Ergo Tools PE-ALB 18 Li BASIC Traduction De La Notice Originale

5. Before starting the equipment

5.1 Fitting the blower tube (Fig. 3)
Plug the blower tube (Item 1) to the motor unit (Item 3).
5.2 Fitting the battery pack (Fig. 4a/4b)
Press the pushlock button of the battery pack as shown in Fig. 4a
and push the battery pack into the mount provided. When the battery
pack is positioned as in Fig. 4b, make sure that the pushlock button
latches in place! To remove the battery pack, proceed in reverse or-
der.
5.3 Charging the battery (Fig. 5)
1. Take the battery pack out of the equipment. Do this by pressing
the side pushlock buttons.
2. Check that your mains voltage is the same as that marked on the
rating plate of the battery charger. Insert the power plug of the
charger into the mains socket outlet. The green LED will then be-
gin to fl ash.
3. Insert the battery pack into the battery charger.
4. In the section entitled „Charger indicator" you will fi nd a table with
an explanation of the LED indicator on the charger.
The battery pack can become a little warm during the charging. This
is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging contacts
If the battery pack still fails to charge, take
•
the charging unit
•
and the battery pack
to your Hornbach store.
Anl_PE_ALB_18_Li_Basic_SPK7.indb 211 Anl_PE_ALB_18_Li_Basic_SPK7.indb 211
- 211 -
GB
21.01.16 16:02 21.01.16 16:02