BST ALPHA-10X Mode D'emploi page 4

Thank you for having chosen our active system. For your own safety, please read this user manual carefully before installing the device.
SAFETY INTRODUCTION
• If the device has been exposed to temperature changes due to environmental changes, do not switch it on immediately. The arising
condensation could damage the device. Leave the device switched off until it has reached room temperature.
• It is essential that the device is earthed. A qualified person must carry out the electric connection.
• Make sure that the available voltage is not higher than stated at the end of this manual.
• Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to replace the power cord.
• Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord by plug. Never pull out
the plug by tugging the power cord.
• DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.
CAUTION:
1. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep away from children and
non-professionals.
2. The light doesn't include any spare parts for repair, please check if all the parts are well installed and screws are fitted tightly before
operating. Do not use the light when the cover is open.
GENERAL GUIDELINES
• This device is only allowed to be operated with an alternating current of max. 110-240VAC/50-60Hz and was designed for indoor use only.
• Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not qualified for operating
the device. Most damages are the result of unprofessional operation.
• Please use the original packaging if the device is to be transported.
• For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other operation may lead to short-
circuit, burns, electric shock, crash, etc. If this device will be operated in any way different to the one described in this manual, the product
may suffer damages and the guarantee becomes void.
DESCRIPTION
6. SUBWOOFER LEVEL CONTROL
This adjusts the subwoofer level. Use this as a starting point for setting the balance between the subwoofer and the sat speakers.
7. POWER SWITCH
Use this switch to turn the system on and off. Make sure the signal source s level control is turned down before you turn it on.
8. POWER SUPPLY SOCKET
This is where you connect the AC linecord to provide AC power. Plug the linecord into an AC socket properly configured
for your particular model.
9. FUSE
When occur a problem on this appliance, the fuse will be cut off power to prevent from a problem. To replace, use standard fuse as
specified on this appliance.
ENGLISH
1. LINE INPUT ( COMBO XLR / JACK )
A line device ( as cd player, mp3 player, dvd player or mixer ) can
be connected to this combo XLR-Jack input.
2. LINE OUTPUT ( COMBO XLR / JACK )
This output is plugged in parallel of the line input . Use a XLR-XLR
cable or a Jack-Jack cable ( balanced ) to link this output to the line
input of another active speaker or power amplifier
3. SATELLITE SPEAKER OUTPUT ( TURNLOCK )
Connect these turnlock outputs to the two satellite speakers.
Connexion : +1/-1
4. PEAK LIGHT
The signal peak indicator that prevents the amplifier outputs from
over driving the transducers. The PEAK indicator lights when the
limiter is activated. It s okay for the PEAK indicator to blink
occasionally, but if it blinks frequently or lights continuously, turn
down the level control until the PEAK indicator only blinks
occasionally.
5. SATELLITE LEVEL CONTROLS
This knob is used to control the pan, adjust how much of the signal
is sent to the left and right output level. The best result to balance
the top is in the 3 o clock (afternoon) position
Utilisez ce réglage pour ajuster le volume du caisson de basse.
4