Linkoln PowerLuber 1400 Mode D'emploi page 12

Model 1400, 1440, 1442, 1442E, 1444, 1444E
PowerLuber Grease Gun
Condition
Motor fails to run.
PowerLuber fails to dispense grease.
PowerLuber continues to lose prime.
Battery fails to take a charge.
Page Number - 12
TROUBLESHOOTING
Possible Cause
- Battery needs charging.
- Faulty wiring to motor.
- Grease tube assembly is out of grease.
- Loss of prime.
- Ball check item 19 is not functioning.
- Air may be trapped in several locations
in container after bulk filling.
- Follower may be binding in grease
tube assembly.
- Charger may not have power.
- Battery may be bad.
Corrective Action
Recharge battery.
Remove battery, disassemble handle and
check wiring for loose connection.
Check that grease tube assembly has grease.
Repeat priming operation.
Remove Items 19 and clean and
inspect ball seat area.
Empty grease tube assembly, refill and
repeat priming instructions.
Replace grease tube assembly Item 2.
Check that receptacle has power.
Replace battery.
Form 402020