Electrical Connection; Water Unloading; A - Emptying The Tank; B - Continuous Water Unloading - Olimpia splendid AQUARIA SLIM 12 P Instructions Pour L'installation, L'emploi Et L'entretien

2.3 - ELECTRICAL CONNECTION

The appliance is fitted with a power cable with plug.
Before connecting the appliance, make sure that:
• The voltage and power frequency values match those specified on
the appliance plate data.
• The power supply line is equipped with an efficient ground connection
and that it is correctly dimensioned for the maximum absorption of
the appliance.
• The appliance's power network must be equipped with a suitable omnipolar disconnection device
compliant with national installation regulations.
• The appliance is powered solely through a socket compatible with the plug provided.
CAUTION
Any replacement of the power cable must be carried out solely by Olimpia
Splendid technical support or by similarly qualified personnel.

3 - WATER UNLOADING

3.1.a - Emptying the tank

• When the led
(7).
• Remove the tank (7) from the appliance body working with both hands (Fig.7).
• Empty the tank by holding it from the specific handle (7a) (Fig. 8).
Do not remove the float (7b) from the water tank (7).
The full water sensor won't be able to correctly detect water level anymore.
• Correctly reposition the tank (7) in the appliance body, otherwise the led
appliance doesn't work.

3.1.b - Continuous water unloading

• If desired, it is possible to connect the supplied hose (14) to the connection (13) to continuously drain water
collected by dehumidification.
• Switch off the appliance and disconnect the plug from the power socket.
• Remove the tank (7) from the appliance body (Fig. 7).
• Remove the pre-cut wing (20) (Fig. 9).
• Connect the rubber hose (14) with an internal diameter of 9,5mm to the connection (13) (Fig. 9).
• It is advised to fix the hose (14) to the connection (13) using a clamp (not supplied).
• Correctly reposition the tank (7) in the appliance body making the hose (14) pass in specific seat located in
the tank (7). If this operation is not completed, the led
Make sure the rubber hose (14) doesn't exceed the exhaust joint height,
otherwise water will remain in the appliance and could cause a malfunc-
tion, damage it and/or cause dangerous work conditions.
During operation with continuous unloading, do not remove the water tank.
Possible problems caused by the external water drain are not detected by the full
tank alarm.
An efficient supervision is necessary in order to prevent malfunctions, damages to
the appliance and/or dangerous work conditions.
switches on, the appliance stops, the buzzer rings and it is necessary to empty the tank
remains turned on and the
remains on and the appliance doesn't work.
AQUARIA SLIM
EN - 20