FLIR LOREX LNZ3522B Manuel D'utilisation page 25

5
Installation
6. Align the 3 notches on the side of the dome camera with the pegs on the
metal mounting plate. Push the camera gently into the mounting plate until
it 'clicks'.
If you are drilling a hole for the camera
cable, ensure that you run the cable
through the cable hole in the metal
mounting plate. See image below for
reference:
1. Pegs (x3); 2. Notches (x3)
The pegs and notches only align one way. Do not force the camera to fit into the metal
mounting plate.
#LX400043; r. 2.0/40122/40365; en-US
CAUTION
NOTE
If you run the cables along the mounting
surface, you must run the cable through
the cable notch on the camera base
and underneath the metal mounting
plate. This will keep the camera base
flush to the surface when mounted. See
image below for reference:
19