Applications; How To Install - Trebs 99715 Mode D'emploi

APPLICATIONS:

* Flower beds * Bird bath/ feeders * Gardens, lawns and yards
* Near ponds to protect fish * Indoors (may require pet dog or cat intrusion prevention)
* To scare intruders during night time

HOW TO INSTALL

1. Simply remove the main module from the mounting shelter gently. The main module
will slide out.
2. Slide open the cover of the battery compartment at the back of the main module and
install two new 9V alkaline batteries.
3. For the main operation, plug the proper adapter into the electric outlet.
4. Replace the main module by pushing it into the mounting shelter. Attach the unit to a
post or the wall of a building using the mounting hole and the supplied screw. You may
mount shelter between 30-90 cm from the ground to wall or a post.
5. Turn the power switch to "ON" position. After 30 seconds of warming up, you may see
the flashing strobe with inaudible/audible sound. You may push the function button to
shift the inaudible sound to audible sound to repel specific animals according to your
need.
6. Leave your Animal-Away on 24 hours.
PLEASE NOTE
Turn off the Animal-Away if your pet will be in the protected area. If using the unit
indoors, ensure the pet is not trapped in the protected area but is able to leave the
area.
When anyone is in the protected area, turn off the device to preserve battery life.
Do not immerse the device in water or any other liquid.
Do not tamper with the device's internal components.
The PIR detection system turns on and off as the animal's body heat moves into or
out of the detection zone.
Make sure the detecting lens is clean. Do not handle the lens with bare hands.
When necessary, use a damp cloth to gently wipe off any dust.
SPECIFICATIONS
Dimension:
Weight:
Power supply:
Power:
Frequency range:
Protection coverage:
LED flashing strobe life: up to 100,000 hours
CE
110 x 100 x 95 mm
255 g
9V (2x9V alkaline battery)
AC adaptor (optional):
100 – 240 VAC; Output: 9VDC 200mA
Standby current: 0.16mA
Exit delay time for ultrasonic: about 25 seconds
Warm up time: about 30 seconds
18,000 Hz to 24,000 Hz approx..
(randomly and continuously variable)
fan shaped area of 70 degree at a distance of 12 meters
(up to 85 square meters)