HandHeld Quick Check 890 Guide De Démarrage Rapide page 5

Connect the QC890 Verifier to the host as shown in the illustration below.
Next you must install the USB driver for the QC890.
1. After plugging the USB cable into your PC, the Windows Found New Hard-
ware Wizard opens. Do not let Windows try to install the driver automati-
cally. Click on No, not this time then click on Next.
2. Choose Install from a list or specific location (Advanced) then click on
Next.
3. Click on Don't search. I will choose the driver to install. and click on Next.
4. Scroll down to Ports (COM & LPT) and click on it to highlight it. Click on
Next.
5. A message will appear, "(Unable to find any drivers for this device)". This is
OK. Click on the Have Disk button.
6. The Install From Disk window opens. Click on Browse.
7. Browse to the location where you saved the ImageData software when you
installed it from the CD and open the drivers\USBCOMPortEmulation
folder. If you used the default location, it will be in C:\Program Files\Hand
Held Products\Quick Check ImageData\drivers\USBCOMPortEmulation.
Click on the file hhpcdc.inf and click on Open.
8. You will now be back at the Install From Disk window. Click on OK.
9. On the next screen you will see the QC890 Verifier as one of the hardware
options. Click on it and click on Next. Click on Finish to close the Found
New Hardware Wizard.
1
2
EN-3