General Safety Instructions; Installation And Maintenance; Waste Disposal - Western Co WRM30+ Manuel De L'utilisateur

General safety Instructions

•
It is mandatory to read this manual carefully before installing or using the product.
•
If the product is not installed and used as described in this manual the product cannot be considered safe, so it
could damage people or animals.

Installation and maintenance:

•
The product must be installed only by qualified personnel.
•
Make sure that the batteries in use are compatible with the product by checking the battery type, the nominal
voltage and the charging voltage on their data sheet.
•
Make sure that the battery room is properly ventilated as indicated in the battery installation manual.
•
When connecting the battery, sparks can occur which can damage the operator's retina.
•
When the photovoltaic module is exposed to the sun it generates voltage. If the panel has voltage Voc> 50V it is
mandatory to use isolating gloves to protect the installer from electric shock.
•
For battery maintenance refer to the battery maintenance manual.
•
The product cannot be repaired by the user or by the personnel performing the installation; it must not
therefore be opened or left working with the panel open.
•
Do not install the product in a place where gas or dust explosions may occur.
•
Protect cables with suitable fuses from the short-circuit, in particular it is mandatory to place a fuse of adequate
current on the battery cable as close as possible to the positive battery terminal.
Warranty
Western CO. Srl guarantees the good quality and good design of its own Products obliging itself, during the warranty
period of 5 (five) years, to repair or replace at its sole discretion, for free, those defective parts owing to poor quality of
material or defect in workmanship. The defective product must be returned to Western CO. Srl or to the company
delegated by Western Co to make product support, at customer's expenses, together with a copy of the invoice both for
repairing and warranty replacement. The costs of re-installation of the equipment will be borne by the customer. Western
CO. Srl will bear the transport expenses of the repaired or replaced product. The warranty does not cover Products that,
according to our discretion, are defective due to natural wear, showing damages caused by incompetence or negligence
of the customer, imperfect installation, by tampering or other interventions different by the instructions supplied by us.
The warranty is not valid also in case of damages coming from: - transport and/or incorrect storage of the product. - force
majeure or catastrophic events (frost to temperatures below -20 ° C, fire, flood, lightning, vandalism, and so on). All of
the abovementioned guarantees are the sole and exclusive agreement which supersedes any proposal or agreement, oral
or written, and any other communication made between the manufacturer and the purchaser in respect of the above.
For any dispute the jurisdiction is Ascoli Piceno.

Waste disposal

Western CO. as manufacturer of the electrical device herein described and in accordance with DL
07/25/2005 n 151, informs the consumer that this product, once abandoned, must be delivered
to an authorized collection centre or, in case of purchase of an equivalent equipment, it can be
returned free of charge to the distributor of the new equipment. The penalties will be applied by
individual Municipalities.
WRM30+
User manual
Danger, electric shock Danger, hot surface
2
EN