Taurus L Série Manuel D'utilisation page 8

Frequency range:
• Horizontal Frequency: 15 – 125 kHz Multisync;
• Vertical frequency: 48 – 85 Hz;
• Pixel clock max 135 MHz.
VGA Standard input signals:
RGB analogue, 0.7 ~ 1VPP level ON 75 ohm impedance HD15F (See section "INPUT SOURCE").
Supported resolutions:
• VGA/SVGA/XGA/SXGA/UXGA 100hz;
• Plug & Play;
• Separated / composite syn;
• 0.3 ~ 5Vpp +/- level.
Other input signals (Optional):
• DVI -D Plug & Play;
• CVBS multistandard (PAL-SECAM-NTSC);
• S-VIDEO multistandard (PAL-SECAM-NTSC).
More input signals (With additional input boards)*:
RGB TTL:
• Signal level: < 0.4 > 2.5Vpp (1Kohm);
• Sync signals: TTL separated/composite;
• Sync level: 0.3 ~ 5Vpp +/-.
Two TTL additionals inputs boards includes the following connectors:
Board1 - D-SUB9 F
- D-SUB15 F
Board2 - SUBD15M (ANALOG)
- HD15F (ANALOG STD)
- D-SUB9 F (ANALOG)
- FLAT (IDC) 14P M (TTL)
• RGB ANALOGUE:
◊ Signal: positive analogue;
◊ Signal level: 0.7 ~ 1Vpp (75 ohm);
◊ Sync signals: separated/composite;
◊ Sync level: 0.3 ~ 5Vpp +/-;
◊ Sync on green: 0 ~ 0.5Vpp level.
- RGB additional boards:
• SCART RGB additional input board includes the following connectors:
◊ SCART F;
◊ STOCKO 12 pin M.
• BNC RGB additional input board includes the following connectors:
◊ 5 x BNC;
◊ FLAT (IDC) 10 pin M "SIN3";
◊ FLAT (IDC) 10 pin M "MRPS";
◊ FLAT (IDC) 16 pin M "SIN3".
* Note: In the monitors with additional input boards the video (CVBS & SVHS) and DVI
inputs are not available.
8
MNL203.1