Warning Information - Sunex Tools 5222 Mode D'emploi

Masquer les pouces Voir aussi pour 5222:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

WARNINg INFORMATION

This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
IMPORTANT: READ THESE INSTRUCTIONS BEFORE OPERATING
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsibility of
the device owner to keep this manual intact and in a convenient location for all to see and read. Contact Sunex Tools for a replacement
label if your stand's label is not readable. If the operator is not fluent in English, the product and safety instructions shall be read to and
discussed with the operator in the operator's native language by the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
THE NATURE OF HAZARDOUS SITUATIONS
WARNING
The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device
who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles
and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads,
overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.
METHODS TO AVOID HAZARDOUS SITUATIONS
WARNING
Read, study, understand and follow all instructions before operating this device.
User and bystanders must wear eye protection that meets ANSI Z87.1 and OSHA standards.
Inspect crane before each use. Do not use if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or unstable due to
loose or missing hardware or parts. Take corrective action before using.
Never get under the load being lifted or suspended.
Use only on a hard level surface.
Do not raise the boom if the crane is equipped with a foldable or storable leg feature and the legs are in the upright position.
Use only slings or chains with a rated capacity greater than the weight of the load being lifted.
Do not exceed rated capacity.
Do not lift or move a load that has a center of gravity extending beyond the front wheels.
Do not allow load to swing or drop violently while raising, lowering or moving.
Do not use (or modify) this product for any other purpose than that for which it was designed without consulting the manufacturer's
authorized representative.
Before moving, lower load to the lowest possible point.
No alterations shall be made to this product and do not use any unapproved attachments.
This product may contain one or more chemicals known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
Failure to heed these warnings may result in serious or fatal personal injury and/or property damage.
CONSEQUENCES OF NOT AVOIDING HAZARDOUS SITUATIONS
WARNING
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
5222
WARNING: Indicates a hazardous situation
WARNING
which, if not avoided, could result in death
or serious injury.
2
rev. 01/14/15

Publicité

Table des Matières
loading

Table des Matières