Installation; Unpacking And Levelling - Indesit IWDE 127 Mode D'emploi

Installation

! This instruction manual should be kept in a safe
GB
place for future reference. If the washer dryer is
sold, transferred or moved, make sure that the
instruction manual remains with the machine so
that the new owner is able to familiarise himself/
herself with its operation and features.
! Read these instructions carefully: they contain
vital information relating to the safe installation and
operation of the appliance.

Unpacking and levelling

Unpacking
1. Remove the washer dryer from its packaging.
2. Make sure that the washer dryer has not been
damaged during the transportation process. If it
has been damaged, contact the retailer and do not
proceed any further with the installation process.
4. Close off the holes using the plastic plugs
provided.
5. Keep all the parts in a safe place: you will need
them again if the washer dryer needs to be moved
to another location.
! Packaging materials should not be used as toys
for children.
Levelling
1. Install the washer dryer on a flat sturdy floor,
without resting it up against walls, furniture cabi-
nets or anything else.
16
3. Remove the 4 protec-
tive screws (used during
transportation) and the
rubber washer with the
corresponding spacer,
located on the rear part
of the appliance (see
figure).
2. If the floor is not per-
fectly level, compensate
for any unevenness by
tightening or loosening
the adjustable front feet
(see figure); the angle of
inclination, measured in
relation to the worktop,
must not exceed 2°.
Levelling the machine
correctly will provide it with stability, help to avoid
vibrations and excessive noise and prevent it
from shifting while it is operating. If it is placed on
carpet or a rug, adjust the feet in such a way as
to allow a sufficient ventilation space underneath
the washer dryer.
Connecting the electricity and wa-
ter supplies
Connecting the water inlet hose
3. Make sure that the hose is not folded over
or bent.
! The water pressure at the tap must fall within
the values indicated in the Technical details table
(see next page).
! If the inlet hose is not long enough, contact a
specialised shop or an authorised technician.
! Never use second-hand hoses.
! Use the ones supplied with the machine.
1. Connect the supply
pipe by screwing it to a
cold water tab using a
¾ threaded connection
(see figure).
Before performing the
connection, allow the
water to run freely until
it is perfectly clear.
2. Connect the inlet
hose to the washer dr-
yer by screwing it onto
the corresponding wa-
ter inlet of the applian-
ce, which is situated on
the top right-hand side
of the rear part of the
appliance (see figure).