VONROC SG502DC Traduction De La Notice Originale page 9

Model No.
Battery Type
Voltage
Capacity
Recommended charger
Weight
Only use the following batteries of the VONROC
VPOWER 20V battery platform. Using any other bat-
teries could cause serious injury or damage the tool.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The following charger of the can be used to charge
these batteries.
CD802AA Quick charger
The batteries of the VONROC VPOWER 20V battery
platform are interchangeable with all the VONROC
VPOWER 20V battery platform tools.
Vibration level
The vibration emission level stated in this instruc-
tion manual has been measured in accordance
with a standardized test given in EN 62841; it may
be used to compare one tool with another and as
a preliminary assessment of exposure to vibration
when using the tool for the applications mentioned.
• Using the tool for different applications, or with
different or poorly maintained accessories, may
significantly increase the exposure level.
• The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keep-
ing your hands warm, and organizing your work
patterns.
DESCRIPTION
The numbers in the text refer to the diagrams on
pages 2 - 4.
1. Trigger
2. Spray flow adjustment knob
3. Handle
4. Battery (not included)
5. Battery unlock button
WWW.VONROC.COM
CD803AA 6. Connection latch
7. Spray unit
Lithium-Ion
8. Motor unit
20V
9. Spray volume adjusting wheel
10. Container cap
4.0 Ah
11. Container
CD802AA
12. Stirring rod
0.65 kg
13. Nozzle needle (2.5mm assembled on machine)
14. Nozzle (2.5mm assembled on machine)
15. Nozzle head
16. Nozzle adjusting ring
17. Nozzle nut
18. Needle key
19. Cleaning needle
20. Screws
21. Air filter cover
22. Air filter
23. Riser pipe
24. Nozzle needle (1mm)
25. Nozzle (1mm)
26. Nozzle needle (1.8mm)
27. Nozzle (1.8mm)
28. Battery LED indicators button
29. Battery LED indicators
30. Charger
31. Charger LED indicators
3. ASSEMBLY
Inserting the battery into the machine (Fig. C-1)
1. Insert the battery (4) into the base of the machi-
2. Push the battery further forward until it clicks
Removing the battery from the machine (Fig. C-1)
1. Push the battery unlock button (5)
2. Pull the battery (4) out of the machine like
Before any work on the power tool, remove
the battery.
The battery must be charged before first
use.
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
ne as shown in Fig. C-1.
into place.
shown in Fig. C-1.
EN
9