American Hometec AHQ-TC10 Manuel D'installation Et D'utilisation page 6

3) Caution: DO NOT INSTALL IN A BATH ENCLOSURE OR SHOWER STALL .
For Canada Only (required standard language that does not apply to this
Coilless Technology® tankless): DO NOT CONNECT TO A SALT
REGENERATED WATER SOFTENER OR A WATERSUPPLY OF SALT WATER
4) Do not install the water heater in cold location, below the freezing point
ofwater (32
5) Clearance required: Clearance required:5" above, 10" below, 2" to each
side and 5" in the front.
6) Do not install the water heater near engine compartments or fuel tanks.
2. Mount
1) Use theWall mounting bracket(B) and a pencil to mark the location of the
holes(2 on the top and 2 on the bottom). The template will ensure
clearancerequirements are maintained.
2) Attach the wall mounting bracket (B) to wall using the anchors and screws
provided.
3) Lift the water heater and slide the tab of the wall mounting bracket on the
backof the water heater (A) over and into the opening on the wall
mountingbracket (B) as shown in Figure 3. Lock them by the screws (2 on the
top and 2 on the bottom)provided.
4) Note: Only licensed professionals should open the cover panel of
Figure 3: Mounting
Diagram
F / 0 C).
o o
6
-