Disinfecting The Whirl System - DURAVIT Air-System Notice D'utilisation

cleaner).
> Avoid contact with acetone; rinse the tub with clean water immediately in case of
contact.
> Avoid contact with nail polishes, lipsticks and all hair dyes. Stains of this type can
only be removed by sanding.
> Do not use abrasive or hard sponges.
Recommendations for cleaning DuraSolid A
Material/surface
DuraSolid A
(daily cleaning)
DuraSolid A
(heavier soiling)
Table 2: Recommendations for cleaning DuraSolid A
5.3 Disinfecting the whirl system
CAUTION
Chlorine bleach irritates the skin.
> Observe the safety instructions on the disinfectant label.
> Do NOT bathe in the whirltub while disinfecting it.
> Ensure that the room is well-ventilated during the disinfection process.
Disinfect the whirl system before using it for the first time, and then after every tenth
bath, but at least once a month and after a long period of no use.
> Fill the tub with water.
> Add 2% chlorine bleach to the water in accordance with the manufacturer's instruc-
tions (approx. 15 ml).
> Turn on the air nozzles for 20 seconds.
Cleaning agent
Water
Detergent,
vinegar-based
cleaner, scouring
agent
Cleaning
equipment
Soft, damp cloth > Clean the surface with a
or soft sponge
> Remove heavier soiling
Magic cleaning
eraser, cloth or > Wipe with a slighly damp
sponge
> Dry the surface with a
Cleaning
soft damp cloth.
with warm water and the
recommended cleaning
agent that you apply to
the cloth/sponge.
cloth afterwards.
soft cloth.
21