GE IM-4D Manuel D'utilisation Et D'installation page 13

PLUG IN THE ICEMAKER
5
Holding the icemaker in place, insert the icemaker
power cord plug into the socket on the side wall,
making sure the prongs and holes are matched. Press
the plug firmly into the socket. Lock the plug in place
by clipping the restraints onto each side of the plug.
Make sure the restraints click into place and the power
cord is still in the hook on the back of the icemaker.
MOUNT THE ICEMAKER
6
• Lift the icemaker so the fill tube that was already
installed in the refrigerator fits in the fill cup
opening. Hang the icemaker on the two mounting
screws in the side wall.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube
the back of the icemaker. (Check the rear of the
refrigerator to make sure the fill tube has not been
pushed out of the back of the refrigerator).
• The icemaker mounting screws are located in
the uppermost position of the mounting slots on
the icemaker bracket.
• The icemaker is level.
• The icemaker power switch is set to OFF.
THEN SECURELY TIGHTEN THE ICEMAKER
MOUNTING SCREWS.
Installation Instructions
13
RE-INSTALL THE SHELF SUPPORT,
7
BUCKET, SHELF AND BASKET
Replace the center vertical shelf support, ice bucket,
chiller shelf and storage basket by reversing the steps
in Step 1.
ATTACH WARRANTY LABEL
8
A label (7) is provided with this kit to record the date
of installation for warranty purposes. Apply it to the
back of the refrigerator.
KEEP THIS MANUAL
9
The warranty for the icemaker is printed in this
manual. Keep this manual with your Refrigerator
Owner's Manual.
The icemaker installation inside the freezer is now
complete. Continue to the Water Valve Assembly
section on page 16.