General Notes - Bego Varseo XS Guide Rapide

General notes

• Please install and use the printer in a well-ventilated area. The distance to the wall must
be at least 10 cm to ensure that there is enough space for proper device ventilation.
• For safety reasons, please put on safety goggle before commissioning the printer.
• Please make sure that the recommended operating temperature of between 20°C and
30°C as well as the relative humidity between 40% and 60% are maintained. If the ope-
rating temperature specified on the label of the resin bottle to be used deviates from the
operating temperature recommended above, please adhere to the conditions specified on
the label.
• Protect the device against frost, direct sunlight and/or ultraviolet radiation. Avoid instal-
ling the device close to heat sources (e.g. radiators, ceramic ovens).
• Colour pigments may deposit on the bottom of the resin bottle or resin tank if the printer
is not used for more than one week. Shake or stir the resin thoroughly before using it.
• Please observe the corresponding resin's directions for use.
• The resin tank is a wear part. It should be replaced if the bottom of the tank is damaged
or hazy to warrant the print quality.
• To warrant the print quality, different resins and/or colours should be used with separate
individual resin tanks.
1. Switching on & selecting the language
• Connect the device to a power supply outlet
cord.
• Switch the device on with the power switch
selected language will automatically appear on the display
• Select the desired display language using the up and down buttons
• Confirm your selection with the OK button
15
LANGUAGE [EN] BEGO VARSEO XS
„ FUNCTIONS
ニホンゴ
FRANCAIS SETTINGS
„ DEUTSCH INFO
8 with the supplied power supply unit and the power
. After switching the device on for the first time, the
1
.
5
.
14
.
2. Raising the build platform
Upon delivery, the build platform is set to pack mode.
2
• In order to raise the build platform you must first place the cover on the device.
• Call up the following menu items and confirm every selection with the OK button
BEGO VARSEO XS FUNCTIONS
„ FUNCTIONS „ MOVE PLATFORM
SETTINGS EXPORT BCP FILE
INFO
TASK COMPLETED
[OK] TO FINISH
• The display indicates the successful completion of the movement.
• Press the HOME-button to call up the main menu.
12
• Remove the protective material from the resin tank
3. Establishing a network connection
The Varseo XS printer must always be online to execute print jobs. The network connection
can be established via LAN (3a.) or WIFI (3b.).
Both, the PC and the printer, need to be in the same network in order to send print
jobs directly from the computer to the printer.
3a. Network connection via LAN
A LAN cable is not included in the scope of delivery.
Use at least a CAT5e patch cable with a RJ45 connector.
The device is set to LAN connection by default. If your network supports DHCP, the device
will connect with your network automatically.
• Connect the device by plugging the LAN cable into the ethernet socket
the device and into the "LAN" socket of your router / network connection.
Quick guide Varseo XS
:
15
MOVE PLATFORM MOVE PLATFORM
„ TO TOP TO TOP NOW?
TO BOTTOM NO
FOR TRANSPORT „ YES
and save it.
4
on the back of
10
7