WSS SPRINT PURA 150 Notice De Montage Originale page 11

2.3. Drill sliding track A using the tentacle G as template Ø 3.5 – 3.8 mm. Install tentacle G to the
sliding track A using the countersunk screw G (ST 4.2 x 9.5 mm) as shown in fig. 3.
3
2.4. Remove protective film from adhesive pads K on the glass clamps I and J. Select the
appropriate gaskets L for the glass thickness and fix onto the glass clamps I and J using
adhesive pads K.
4
Glass thickness Gasket
8 mm 3.2 mm
10 mm 2.2 mm
12 mm 1.2 mm
2.5. Pre-assemble glass clamp I and J onto the glass using the countersunk hexagon socket
screws M (M 8 x 20) and hexagon wrench key SW5 (DO NOT FIX!).
5
278
I J
M
H
L
K
GB 11