WSS SPRINT PURA 150 Notice De Montage Originale page 10

1.3 Preparations
Glass, fittings, gaskets and cover have to be dust- and grease free. If necessary, please
clean with alcohol.
1.4 Adhesive pads
The adhesive pads have a high adhesive strength. The final strength will be achieved after
24 hours.
2. Assembly
In case of initial assembly of the sliding door system with SOFT-STOP the catch plate D has
to be removed before installation (not required when using SOFT-STOP).
2.1. Mark position of the track stop B. Loosen grub screws C using hexagon wrench key SW3.
When retrofitting with SOFT-STOP, slide track stop B sideways out of the sliding track A
and remove catch plate D by loosening the screws E and F. Install track stop B back to the
marked position. Should this not be possible on-site, start with step 2.
1
A B
2.2. Align tentacle G using assembling aid Q as shown in fig. 2a and secure with grub screws C.
If the catch plate D could not be removed on-site, deform the catch plate D a bit using a
hammer and punch (on-site) as shown in fig. 2b. For wall installation, support the sliding
track A beforehand towards the ceiling (e.g. using a square piece of wood or similar).
2a
flush
2b
10 GB
C F
E
D
G
Q