Table des Matières
Publicité
• The mains cable must not come into contact with any hot parts of the appliance.
• Do not immerse the appliance in water or any other liquid.
• Do not exceed the maximum filling volume as indicated on the appliances.
• This appliance is intended for domestic use only. The manufacturer cannot accept
any liability for possible damage caused by improper or incorrect use.
• Be careful when turning a steam iron upside down – there may be hot water in
the reservoir.
IRONING CHART
FABRIC
Acrylic
Acetate
Nylon & Polyester
Rayon
Viscose
Silk
Cotton blends
Wool & Wool blends
Cotton
Corduroy
Linen
Denim
Varied ironing speed and fabric dampness might cause optimal setting to differ from that recommended in the
table!
TIPS AND TRICKS
Temperature settings
The iron heats up faster than it cools down, so we recommend that you start ironing the fabrics requiring the lowest
temperature. Use the lowest temperature with fabrics that have unusual finishes, such as sequins or embroidery. If you
are unsure about the fabric, start with a low temperature and iron on a hidden corner. Then increase the temperature
gradually if needed.
Avoiding marks on the fabric
Never iron areas with traces of perspiration or other marks, the heat fixes the stains on the fabric.
Washing fabrics before ironing
If the washing machine is heavily loaded or the spin drying revolutions are very high, the fabrics may come out more
creased. However, many fabrics are easier to iron if they are damp.
www.electrolux.com
www.eluxshop.hu
www.markabolt.hu
TEMPERATURE SETTING
to "MAX"
to "MAX"
IRONING RECOMMENDATION
Dry iron on the wrong side.
Dry iron on the wrong side while still damp or use spray
to dampen.
Iron on the wrong side while still damp or use spray to
dampen.
Iron on the wrong side of fabric.
Mainly dry iron. Steam can be used under
manufacturer's instructions.
Iron on the wrong side. Use an ironing cloth to prevent
shine marks.
Check the label and follow the manufacturer's
instructions. Use setting for the fibre requiring lowest
setting.
Steam iron on the wrong side or use ironing cloth.
Dry iron while still damp or use spray to dampen. Use
steam medium to high.
Steam iron on the wrong side or use ironing cloth.
Iron on the wrong side or use ironing cloth to prevent
shine marks, especially with dark colours. Dry iron while
still damp or use spray to dampen. Use steam medium
to high.
Use maximum steam.
8
Publicité
Table des Matières
