Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
converting to a different type of
gas
Check that the values indicated on the
components correspond with the values in
the accompanying table.
Close the gas tap.
Replace the pressure regulator for natural
gas with the adjusting screw for propane
(or vice versa).
Replace the main injection nozzle with the
nozzle from the conversion kit.
Replace the pilot light injection nozzle with
the nozzle from the conversion kit.
Replace the low-setting restrictor with the
low-setting restrictor from the conversion
kit.
1.
Measurement point for burner
pressure
2.
Measurement point for supply
pressure
3.
Pressure regulator or
adjusting screw
4.
Low-setting restrictor
5.
Pilot light
6.
Mounting bracket
7.
Supply pipe
8.
Burner pipe
9.
Main burner
10. Injection nozzle
11. Taper ring and coupling nut
fig. 7
Replace the settings plate with the settings
place from the conversion kit.
Adjust the burner pressure as per the table
supplied with the conversion kit. In the
case of appliances without pressure
regulator pay particular attention to
whether, with the appliance turned on full,
the supply pressure corresponds with the
appliance's rated inlet pressure.
Check all connections previously
dismantled for leaks.
3
1
4
2
5
9
10 11
lighting
Open the gas tap.
Turn control knob B to position
press it in. Gas will now flow to the pilot
light burner.
fig. 8
Press ignition button A. A spark will now
jump to the pilot light burner. Keep the
ignition pressed in until the pilot light
ignites, then keep knob B pressed in for
approximately a further 10 seconds.
If the pilot light now goes out again, the
6
preceding action has to be repeated and
ignition button B must be held in for a little
longer.
Once the pilot light is lit you can select a
setting between 1 and 7 with thermostat
7
knob B.
8
switching off
If you turn the control knob to the position
between
and 1, only the pilot light will
and
burn. This is also the frost-protection
position, i.e. at this setting the main burner
will only be switched on at a very low
ambient temperature to keep the room
frost-free. You should therefore leave the
A
pilot light on during the heating season.
Turn control knob B to position
heater is now completely switched off.
B
. The
Publicité
Table des Matières
