EIBENSTOCK EZR 22 R R/L Notice Originale page 14

Ensure that persons standing near the machine are at a safe
distance from the work area.
For further safety instructions, please refer to the enclosure.
Before starting the machine, please check the correspondence between
voltage and frequency according to the data mentioned on the identification
plate. Voltage differences of + 6 % and – 10 % are allowed.
The contra twin stirrer is made in protection class II. Only use extension
cables with a sufficient cross section. A cross section which is too small
could cause a considerable drop in performance and an overheating of
machine and cable.
The EZR 22 R R/L is equipped with a start-up speed limiter to prevent that
swift automatic circuit breakers are unintentionally triggered.
Tool Protection
Wrong handling can cause damages on the tool.
Therefor, please always observe the following instructions:
Only use original EIBENSTOCK stirring rods.
Do not allow blocking of the tool.
Switching on and off
The stirrer EZR 22 R R/L is equipped with a lock-off button against
unintentional switch-on.
2
Electrical Connection
Switching-on:
1
Switching-off:
13
To start the tool, press the lock-off
button (1) and pull the trigger (2).
Release the trigger (2) to stop.