Led Signals; Radio Control For Closing Due To Rain (Spr Radio); Environmental Protection - GIESSE SPR/SPR-RADIO Manuel D'utilisation Et D'installation

9.

LED SIGNALS

Rain sensor has 2 signalling LED that indicate the functioning status.
• B - B
led flashing indicates that the sensor is fed.
LUE
• R - R
led lit fix indicates "wet sensor"; it has active command.
ED

10. RADIO CONTROL FOR CLOSING DUE TO RAIN (SPR RADIO)

The SPR RADIO radio rain sensor is a device capable of controlling the VARIA
SLIM RADIO motor remotely through a 433.92MHz signal.
T
HE RAIN SENSOR IS
First follow the instructions provided below concerning the specific operation of the
machines you would like to control, then those of the actuator to be controlled
(VARIA SLIM RADIO).
10.1. Saving the rain sensor on VARIA SLIM RADIO
The SPR RADIO rain sensor, as soon as it senses the presence of rain, transmits a
unique signal at the radio frequency 433.92 MHz. The SPR RADIO rain sensor can
be used to control several actuators, as long as the sensor is associated with the
various VARIA SLIM RADIO actuators and thus a window, with the procedure
described below.
The encoding used varies for each channel, so each transmission will send a signal that
is different from all the others. It follows that the receiver must be able to recognize the
enabled transmitters, thus the transmission codes should be saved following the
procedure below:
▪ Equip yourself with the SPR RADIO radio rain sensor, checking beforehand that
it is working and is powered properly (Blue LED flashing).
▪ On the VARIA SLIM RADIO actuator, briefly press (for about 1 second) the
small " " button located near the terminal block. The slowly flashing LED
PRG
indicates that it is waiting to receive a valid radio code.
▪ Within 10 seconds, place the palm of your hand on the rain sensor (on the grey
circular zone) waiting for the Red LED rain indicator to start flashing.
▪ If the code is saved correctly, the LED on the VARIA SLIM RADIO actuator will
emit one long flash (1 sec.) as confirmation; then the LED will go out and remain
at rest.
▪ If the code is not saved correctly - due to the memory being full, for example, or
the sensor being incompatible - the LED on the VARIA SLIM RADIO actuator
will emit a series of quick flashes for about 1 second; then the LED will go out
and remain at rest.

11. ENVIRONMENTAL PROTECTION

All materials used in the manufacture of this appliance are recyclable. We
recommend that the device itself, and any accessories, packaging, etc. be sent to a
centre for ecological recycling as established from laws in force on recycling. The
NOT -
FACTORY PROGRAMMED
(
ASSOCIATED
23
).