Maintenance Schedule - Husqvarna LC 356VP Manuel D'utilisation

Maintenance schedule

CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
Maintenance
Do a general inspection
Examine the oil level
Clean the product
Examine the cutting equipment
Examine the cutting cover *
Examine the engine brake handle *
Examine the blade brake control *
Examine the muffler *
Examine the spark plug
Replace the oil (the first time after 5 h of use, then after each 50 h of
use)
Clean or replace the air filter
Examine the fuel system
To do a general inspection
• Make sure that all nuts and screws on the product
are tightened correctly.
To clean the product externally
• Use a brush to remove leaves, grass and dirt.
• Make sure that the air intake on the top of the engine
is not blocked.
• Do not use a high pressure washer to clean the
product.
• If you use water to clean the product, do not flush
water directly on the engine.
To clean the inner surface of the cutting
cover
1. Empty the fuel tank.
2. Put the product on its side with the muffler down.
CAUTION:
the air filter down, the engine can
become damaged.
3. Hose down the inner surface of the cutting cover
with water.
1583 - 004 - 23.10.2020
Make sure that the air filter
If the product is put with
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 9 .
Daily
X
X
X
X
X
X
X
To examine the cutting equipment
WARNING:
remove the ignition cable from the spark
plug.
WARNING:
when you do maintenance on the cutting
equipment. The blade is very sharp and cuts
can easily occur.
1. Examine the cutting equipment for damage or
cracks. Always replace a damaged cutting
equipment.
2. Look at the blade to see if it is damaged or blunt.
Note:
It is necessary to balance the blade after it is
sharpened. Let a service center sharpen, replace and
balance the blade. If you hit an obstacle that causes the
product to stop, replace the damaged blade. Let the
service center estimate if the blade can be sharpened or
must be replaced.
To replace the blade
1. Lock the blade with a block of wood. (Fig. 29)
Weekly Monthly
X
X
X
X
X
To prevent accidental start
Use protective gloves
13