Technical Data - REV 0046800 Notice D'utilisation

Choice of melodies
Turn the slide switch of the device to "HI/LOW", after the insertion of the batteries.
1. Open the transmitter on the backside. Over the jumper (25) you can choose the desired
melody. Totally there are three different melodies available.
2. To adjust the different melodies, you have to put the jumper (25) in the three different positions.
Position 1-2 (Big Ben), Pos. 2-3 (two-tone) or don't plug in the jumper (three-tone).
25
16
Change of code in the case of interferences:
If there are interferences with other radio-units or the chime is disturbed by other devices, the
transmitter-code must be changed:
A: Adjust a new sender-code on the sender:
1. Push the button (16) until the LED lights.
2. Push the button (16) once again within 5 seconds. The LED blinks.
3. Now a new code is created.
B: Inherit a new code on the receiver
1. Carry out sequence A.
2. Push button (23) on the receiver, to start the learning process.
3. Push the push-button (15) on the transmitter within 7 seconds. The LED (24) on the
transmitter lights during the hitting.
Note
The weather forecast works not correct within the first 12-24 hours after installation, because the
data for interpretation is not available yet.
Reset
Push „Reset"-button (14) with an acuate object to delete all values.

Technical data

Main station:
Temperature range:
Temperature resolution:
Temperature tolerance:
Metering range of air humidity:
Hygrometer tolerance (at 25°C):
Resolution of air humidity:
Measuring cycle:
Energy demand:
Time:
Positions:
1
25
2
16
3
Melody A
Big Ben
0°C to +50°C (+32°F til +122°F)
0,1°C (or 0,2°F)
0°C to 40°C: +/- 1°C
40°C to 50°C: +/- 1,5°C
20 % to 90 %
40 % to 80 %: +/- 5 %
30 % to 40 %: +/- 8 %
80 % to 90 %: +/- 8 %
20 % to 90 % and > 90 %: no accurate measurements
1 %
30 sec.
6V adaptor and 3 x 1,5V AA LR6 alkaline batteries if
applicable
DCF 77, Crystal operation during malfunction of radio signal
1
1
2
2
3
3
Melody C
Melody B
3 ring
double ring
14