Table des Matières
Publicité
Display for the phase of the moon
full moon
Adjustment of Alarm:
By pushing the button "Alarm" (2) for 3 seconds the hours of the time display "0:00" starts flashing
and the bell symbol "
with buttons 3 and 4 and confirmed by pushing "Alarm" (2) again. The minutes can be selected in
the same manner. By confirming the setting for the minutes the normal mode (display of time) is
shown again.
Read and activate/deactivate the alarm
Read:
Activate:
Deactivate:
Back to normal mode
Alarm signal:
As alarm you can hear a beep sound every second for one minute and then a continuous tone for
one minute. If the button "Snooze/Light" (8) is pushed during that time the symbol "Zz" appears in
the display and the alarm signal is repeated after 10 minutes. Otherwise it is inactive until the next
day.
Adjustment of time zone:
To show the time of another place on the world (e.g. on holidays) the time zone can be adjusted in
the following way:
!
By pushing the button "Zone" (9) for 3 seconds, the display shows "Zone 0".
!
Select desired time zone from +12 to -12 with buttons 3 and 4.
!
Return to normal mode by pushing button "Zone" (9).
Note:
Push "Zone"-button (9) to switch from normal mode to time zone-display. It is shown on the
display by the note "Zone" next to the time.
Display of minimum and maximum temperature and humidity
Maximum:
Minimum:
Back to normal mode:
Delete:
11
%
" and "AL" appear on the display. Now the desired settings can be selected
Press button "Alarm" (2) in normal mode 1x
Press button "Alarm" (2) in normal mode 2x
Press button "Alarm" (2) in normal mode 3x
Press button "Clock" (1) 1x
Press button "MEMORY" (6) in normal mode 1x
Press button "MEMORY" (6) in normal mode 2x
Press button "MEMORY" (6) in normal mode 3x
Press button "MEMORY" (6) for 3 seconds
new moon
Publicité
Table des Matières
