Baby Jogger City GO GRACO CLICK-CONNECT Instructions D'assemblage page 2

EN
1
CLICK
FOLLOW ALL THE INSTRUCTIONS AND WARNINGS IN YOUR STROLLER'S
INSTRUCTION MANUAL.
• Important - Keep these instructions for future reference.
• Read these instructions carefully before use. Your child' s safety may be affected
if you don't follow these instructions.
• Never leave the child unattended.
• IMPORTANT! While the child is in the car seat, always use the restraint system
provided by the manufacturer.
• WARNING: Check that the car seat attachment devices are correctly engaged
before use.
• Accessories not approved by Baby Jogger® shall not be used.
• Only use replacement parts supplied or recommended by Baby Jogger®.
• Wipe clean using a damp cloth.
Car Seat Adapter Installation:
1 Insert Adapter Brackets into the corresponding mounting brackets on your
stroller. The Adapter Brackets are secure when they click into place.
NOTE: Left and right are determined by standing in front of and facing the stroller
and each Adapter Bracket is labeled with an L or an R for your convenience.
2 Place car seat on the car seat adapter brackets and press down firmly until it
clicks into place.
To remove car seat:
Follow the steps in your car seat' s instruction manual to remove car seat from
adapters.
To remove adapters:
Lift up on the release levers on each adapter and pull upward to remove.
2
WARNING
2
CLICK