Remote Control; Power Supply - Trevi SB 8316 TV Mode D'emploi Et Branchement

ENGLISH
13
14
15
16
17
18
19
20
REMOTE CONTROL BATTERY ACTIVATION AND REPLACEMENT
Remove the battery compartment
cover
INSTALLATION NOTE
When installing the SB 8316TV with TV under 24" in size, you may need to lift up the TV so that the sound bar doesn't stand
between the TV infrared receiver and the remote control signal.

POWER SUPPLY

Connect the DC plug of the supplied adapter to the 19V
power adapter to an electrical outlet.
POWER ON/ STANDBY AND AUTO POWER OFF FUNCTION
- Press (9) button on the unit or the button
- Press and hold (9) button on the unit for 2 seconds or press the button
in stand-by mode; the LED indicator (1) will switch On;
- This device has an AutoPower Off function; this function allows automatic shutdown in the absence of audio signal on the
inputs after 15 minutes.
Nota:
• If the sound Base does not react to any operation or does not work properly, disconnect the power cable for 30
seconds to reset the device.

REMOTE CONTROL:

13.
26
14. MUTE button
15.
16.
25
17.
24
18.
23
19.
22
20. 3D button, 3D ON/OFF
21.
21
22.
23.
24.
25.
26. MODE button, cycle through different inputs
Inser 2 "AAA" batteries according to the
markings inside compartment
socket (3) located at the back of the appliance. Connect the supplied
(13) on the remote control to turn on the appliance;
9
button, Power ON/Stand-by
button, Volume turning Up
9
button, prev. song (USB and BT mode)
button, Volume turning Down
button, chose Music sound effect
button, shifting into BT mode
button, USB playback Repeat
button, chose News sound effect
button, chose Movie sound effect
button, Play/Pause
:
button, next song (USB and BT mode)
(13) on the remote control to put the appliance
SB 8316 TV
Close the compartment