GTS Race Chip Manuel D'utilisation page 15

3 Installation
Step 8 of 10 – Connecting the RaceChip and fi rst function test
1
Disconnect the deactivation plug
from the wiring harness
• If (
soon as it was connected, this means that there was still power in the system during
the installation.
• In some cases, this can lead to an error message during the fi rst function test. Please
refer to Trouble Shooting for a solution.
3
Carrying out function test
• Position the RaceChip and the wiring harness safely in the engine bay. Do not fi x
anything in place yet.
• Switch the ignition on. DO NOT start the engine.
• Check for the following:
- Control lights on the dashboard light up and go out as normal.
- The Power ON lamp on the RaceChip lights up (see Overview of the RaceChip).
• If all the above happens, you can start the engine. It should start as normal and
should react to the throttle when idling.
• Switch off the engine and ignition.
• If your car will not start as normal, please refer to Trouble Shooting for hints and tips.
• Our Customer Service is of course always ready to help. See Contact for details.
the Digital User Interface lit up /
2
Connect the RaceChip
the green LED lights up) as
Illustration may
differ
C