Installation Safety; Installation Contents: Bollard And Evse; Power Xpress Evse (El-50600-300) For Bollard Charge Station; Bollard And Hardware (El-50600-500) - Bosch Power Xpress EL-50600-300 Instructions D'installation

en | 2 | Power Xpress™ Bollard Charge Station Installation Guide
1.0

Installation Safety

SAVE THESE IMPORTANT SAFETY INSTRUCTIONS
This guide contains important instructions that must
be followed during the installation of the electric
vehicle supply equipment (EVSE). All instructions
should be carefully read before installation of the
EVSE.
WARNING: Turn OFF the circuit breaker at the
service or distribution panel before performing
any electrical work or repairs.
WARNING: The EVSE should be installed by a
licensed electrician in accordance with all local
electrical codes and ordinances, and all authorities
having jurisdiction.
WARNING: Do not install the EVSE near flammable,
explosive, or combustible materials. Do not locate
or store flammable, explosive, or combustible
materials near the EVSE.
WARNING: Improper installation of the EVSE can
result in personal injury or product damage.
WARNING: This EVSE installation guide is not a
substitute for electrical safety precautions.
WARNING: Use this EVSE within the specified
operating parameters. Failure to do so may result
in injury or death.
WARNING: Locate and install this EVSE in a location
where the charge cable will not be stepped on,
tripped over, or subject to damage or stress.
WARNING: The EVSE must be connected to a
grounded, metal, permanent wiring system, or
an equipment-grounding conductor must be run
with the circuit conductors and connected to the
equipment grounding terminal on the EVSE.
CAUTION: Incorrect installation of the EVSE can
result in damage to the vehicle's battery and to
the Charge Station itself. These damages will void
the warranty for the vehicle and the EVSE.
CAUTION: Do not operate the EVSE in temperatures
beyond its operating range of -40°F to +122°F
(-40°C to +50°C).
578988 | REV. A | 28.10.2016
2.0 Installation Contents: Bollard and
EVSE (EL-50600-300)
2.1 Power Xpress EVSE (EL-50600-300) for Bollard
Charge Station

2.2 Bollard and Hardware (EL-50600-500)

Bosch Automotive Service Solutions Inc.