Additional Safety And Working Instructions - Güde AKKU TACKER AKT 4.10-4 Mode D'emploi

ENGLISH
24
Additional Safety and Working
Instructions
Clamp your workpiece with a clamping device. Unclam-
ped workpieces can cause severe injury and damage.
Do not use the device near flammable liquids or gases. Risk
of fire and explosion in case of short circuit.
Please turn the device immediately off when the tool used
gets blocked! Do not turn the device on again when the
tool is still blocked. This could cause bounce back with a
high reaction moment. Determine and remove the cause
of the blocking of the tool used while respecting the
safety instructions.
The possible causes may be:
• it is tilted in the workpiece to be machined
• it has pierced through the material to be machined
• the power tool is overloaded
Battery
Never use the charger in moist or wet conditions. Suitable
for indoor areas only.
Make sure the system voltage corresponds to the charger
type plate details. There is a risk of electric shock.
Cable connections to be separated by pulling the plug only.
Pulling the cable could damage both the cable and plug.
As a result, electric safety would no longer be guaranteed.
Never use the charger when the cable, plug or the machine
is damaged by external influences. In case damage let
repaired in authorized workshop
The Güde charger to be used only to charge the battery. There
can be malfunction or fire if different chargers are used.
Vapours may leak out in case of unauthorised use or when
using a damaged accumulator. Bring fresh air and seek
medical advice if experiencing difficulties. Vapours may
irritate the respiratory system.
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accu-
mulators. Never open or damage the accumulator
or let it fall on the ground.
Never charge the battery in an environment with
acids and easily flammable materials.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures
between 10°C and +40°C only.
Never put the battery on heaters and do not
expose it to strong sunlight for a long time.
After being subject to heavy load, let the battery
cool down first.
Short circuit - do not bridge the accumulator
contacts with metal parts.
The accumulator must be packaged (plastic bag,
box) or accumulator contacts must be sealed up
for accumulator disposal, transport or storage.