Helite B'safe Manuel D'utilisation page 37

BATTERY
Saddle sensor: has an autonomy of around 5 years.
To check if the sensor is still activated you can place the magnet over the sensor:
- Green LED on the saddle sensor > Battery OK
Red LED on the saddle sensor > Battery is low,
-
The vest has 25h of autonomy. The system is totally automatic and energy saving. It
automatically switches to sleep mode if no movement is detected for 30 seconds.
The vest should be recharged with the USB cable included in the B'Safe package.
We recommend to recharge the vest once a week. (see page 40 How to recharge
B'Safe?).
THE CO2 CARTRIDGE
B'Safe is sold with a new and usable cartridge ready to work.
The cartridge is for single use only and must be replaced after each inflation. We
recommend to store 1 or 2 cartridges and keep them available in the event of an
accident.
It is possible to order CO2 cartridges online on our website www.helite.com or at one
of our dealers.
!
PRECAUTIONS
The CO2 cartridges are for single use only and must be replaced after each inflation.
- The CO2 cartridge must be a Helite branded cartridge ( GG 50cc / GG 60cc / GG 100
cc). Do not use any other cartridge to replace the used one.
- The cartridge must be entirely screwed. Only connect the cartridge after you have
entirely screwed it in the black cylinder.
- The cartridge should be stored and used in temperatures below 45°C. Do not leave
full cartridges in the car in high temperatures for example.
- Never let the cartridge fall down.
- If rust or other corrosive marks appear on the outer surface of the cartridge, change
it immediately and discard the cartridge.
- Never cut the cartridge, do not throw into fire.
- Keep out of children's reach.
User Guide
you must change the saddle sensor.
37