Included Parts - Kawai F-302 Mode D'emploi

F-302 Assembly Instructions
• Do not use this product for any purpose other than its intended use as a piano pedal unit.
• At the fi nal stage of assembly, ensure that all screws are fi rmly tightened.
• Do not drop this product or subject it to strong impact.
• Do not stand on this product or apply undue force on it.
• Regularly check the assembly screws for looseness and re-tighten if necessary.
• If the adjustor is not fi rmly attached to the fl oor, the pedal base may be damaged.
• When moving the piano, be sure to lift and then move without dragging the piano.

Included parts

Before assembling the pedal unit, please make sure that all the parts shown below are included. A Phillips-head screwdriver (not
included) will also be required in order to assemble the pedal unit.
(Including the adjustor)
1. Pull out the pedal cable
Unfasten and extend the pedal connection cable attached
to the bottom of the pedal board
2
A A
Pedal board
A
.
a
Screw (6 x 60 mm) x 4
Caps
b
2. Attach the pedal board
stand (sold separately)
2- 1
A
Fix the pedal board to the stand using four screws
* If it is diffi cult to align the pedal board with the stand,
slightly loosen the screws fi xing the back board
side boards.
* If caps are attached to cover the screw holes of the HM-5
stand, remove the caps.
2- 2
Place the caps b on the heads of the screws
B B
b
a
b
a
A A
A
to the HM-5
a
.
B
to the
a
.
a
b
a
b