Orla CDP 10 Notice D'utilisation page 11

METRONOME
A very useful feature is the Metronome.
To use the METRONOME, push the METRONOME switch, and the pulsed beat selected will be
played though the speakers. The beginning of each measure is indicated by a louder sound.
It is possible to change the tempo speed of the metronome by using the (/\) and (\/) buttons.
To stop the METRONOME, push the METRONOME switch again
The Metronome will start running according to selected Time Signature. Press the Metronome Off
to stop it.
There are different Time Signatures available : Mono Click, 2/4, 3/4, 4/4, 5/4 and 6/8.
How to select the different Time Signatures:
- press the METRONOME button in the FUNCTIONS section and press it for a few seconds.
- The display will show for example:
Using the (/\) and (\/) DATA buttons it is possible to change the Metronome Value.
CONNECTIONS
HEADPHONE
One headphone set, located on the Left of the instrument, below the keyboard can be plugged in
for private practice. They disconnect the speaker system and allow you to play without disturbing
the others being disturbed by outside noise.
OUTPUTS
The two outputs (Left and Right) are used to send the audio signal out to an external amplifier,
mixer console or recording equipment. If you wish to connect the instrument to a stereo system,
connect both Left and Right outputs. If instead you want to use a mono system, just connect one
jack to the L/R output.
MIDI CONNECTIONS
The Midi IN connector receives the Midi data from an external Midi device which can be used to
control the instrument. The Midi THRU connector retransmits any data from the Midi IN directly
to other Midi devices. The Midi OUT connector transmits Midi data generated by the instrument
to other Midi devices.
PEDALS CONNETION
Insert the stereo jack in plug number 2. Insert the mono jack in plug number 1.
4 - 4
11