Cleaning And Maintenance - MSW Motor Technics MSW-ARL-01 Manuel D'utilisation

8. Product MSW-ARL-06 requires the use of stabilizing bars between the two rows
of ramps to prevent the ramps from moving sideways.
9. If handrails are fitted to the ramp, check the mounting bolts regularly and
retighten as necessary.
10. If it is not possible to safely install the ramp with the mounting plate, e.g. due to
a problematic area (rocky, hard ground), install the ramp with an overlap so that
the overlap length is at least 50 cm.
3.2.

Cleaning and maintenance

a) Use only non-corrosive cleaners to clean the surface.
b) The device must be regularly inspected to check its technical efficiency and
spot any damage.